MTM Hydro Low-Flow Foam Cannon Orifice (1.1mm, 3.0)
The MTM Hydro Low-Flow Foam Cannon Orifice allows you to easily change how your MTM Hydro Foam Cannon creates foam with your low pressure/low volume pressure washer. Consider this a must-have item if your pressure washer has less than 3.0 gallons per minute, and/or less than 1,500 PSI.
- To replace the original orifice (1.25mm, 3.5), first remove the Quick Connect Plug from the inlet side of your foam cannon.
- Next, take a small flat-blade screwdriver and unscrew the existing orifice.
- Lastly, screw in the new orifice, and screw the Quick Connect Plug back into the foam cannon.
- You may want to re-seal the Quick Connect Plug with Teflon tape and thread sealant to ensure a water tight fitment.
This product can expose you to chemicals, including DINP/DEHP which is known to the state of California to cause cancer or birth defects or other reproductive harm, go to www.p65Warnings.ca.gov for more information. The products we sell are not intended for use in potable water systems and are only for industrial non-drinking water applications.